Also for the headlights, just put the screw driver in that hole with the gear, and turn the screw driver. The contact between the gear edge and the Phillips screw driver teeth will adjust the aiming of the headlight. Hopefully this helps! you CAN aim the fogs. Take them out and you will see a spring loaded screw. This method creates the most use for the lights. 1. Make sure you measure from the center of the headlight to each passing lamp. Put a parallel vertical line on the way to use as your guide. 2. Adjust the left passing lamp so it shines just inside the left line on the wall and down a touch from the headlamp. Adjust the vertical aim screw of the headlamps to the specifications required by the state and the local authorities, or as shown in step number 8. Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp. Turn the headlamps OFF. Close the hood. It's a 4mm ratcheting tool and it makes adjusting them way easier, even though it only moves the headlight a little bit with each turn. Park your truck on a flat surface about 20-25 feet from a wall and it's easy to see the movement as you're adjusting. To adjust the headlights, have your helper sit in the driver’s seat. Next, raise the hood and locate the adjustment mechanisms. Usually, there are two screws close to each light fixture, one for vertical adjustment and one for horizontal adjustment. To adjust one, block the light from the other using a towel or coat. Properly adjusted headlights project an equal area of light to right and left of center. 7. Adjust headlight aiming if necessary. WARNING A motorcycle’s automatic-on headlight feature provides increased visibility of the rider to other motorists. Poor visibility of the rider to other motorists can result in serious injury or even death. Get a flat road towards a wall. Point the car at the wall about a foot from the wall. Mark the location of the main beam, back up ten feet and see where the beam differs. There's a nylon adjusting screw behind the headlamp that you turn to adjust height. If they're right. Just turn them down a touch more. Reply. 10 Steps How to Adjust Ram Headlights. Step 1. Raise the Hood : To Adjust Ram Headlights, you need to raise the hood of your car. While lifting the hood, make sure you are careful so that you do not damage the body. Make sure to prop it up with the support rod so that it does not close on its own. gnFY.

how to properly adjust headlights